ACME thread taps supplier

ACME taps & Stub-ACME taps

ACME thread taps are used to generate ACME internal thread (2G, 3G,4G)

ACME thread with 29° thread angle, their thread height is half of the pitch, the peak and crest are flat.

ACME  taps are widely used in mass production . Using ACME thread taps has the characteristics of low-cost tool , less-dependent on operation workers and higher thread accuracy etc.

RH（right hand) and LH( left hand) ACME thread taps available. (RH no need specified, LH need to be specified specially)

Material: HSS, HSS-E ( Both material can provide good wear-resistance)

These ACME taps are usually bright ( no-coated), we also can put on coatings according to clients’ requirements.

ACME taps can be supplied by individual or sets( Taper taps, Plug taps and Bottom Taps)

As below are some ACME taps we can provide:

We accept payment of T/T (bank transfer), Paypal.

We usually send goods by express, DHL or UPS.